Activity Stream

I too prefer the sa/da trigger. I put an LEM trigger in my P30, but it just didn't sing to me. I took it out before selling that P30, so it's around...

Galloway's installation video is quite good: https://www.youtube.com/watch?v=QvmBBQCd8b0 I used a chopstick to lever the spring and spacer into...

Of my semi autos; the Hk Light LEM is real close to my MK40 Elite trigger. And they are hammer fired with second strike capability. I'm not sure if...

That is so much me right there, and I have the bruises to prove it.

Hk P2000Sk LEM 357 Sig OWB with two reloads. And a S&W 342 ti Centennial .38 +P BUG. Plus some edged weapons for when the ammo runs out...

Does it say “stainless”? Early Kahrs were carbon steel, either blued or Black T. If it says stainless, someone applied a black finish over it or,...

Tell that to my wife...she is constantly powdering her nose trying to eliminate the shine. I've polished my chamber and feed ramp, but my barrel...

I also polish all my magazines. They also polish up real easy with a buffer. I don't use sandpaper, just the buffer and a little polishing compound....

I filled mine (CM9) with some #4 lead shot until almost full, then cut a very slightly over sized plug out of a rubber fender washer; end result is a...

the barrels are nickel plated and I did mine with some 900 grit paper, followed up with a good Flitzing of the barrel,hood, and ramp; can almost see...

Greg Just stop it! Now I am wanting one!!!!

I have been bouncing around lately....my Sig 365, Shield 45, Ruger SP101 and also my Sig P227 SAS. Depends on where I am going.

I don't carry .380 myself, but the wifey does. I carry .38 spl. +p half the time. We both feel confident in the calibers and although I don't usually...

A little mag wheel polish and a rag will remove the dullness, at least for a while. It won’t be a mirror finish but it will look much better.

I've polished all my Kahr barrels. They polish up very easy and shiny as can be. Shouldn't effect performance one bit, keep it oiled up as normal....

That's a great thought!

Hey Alfonse, There seems to be quite a market for a grip base plug for Kahr pistols like the ones for Glocks....Sure would look better than that ugly...

PM9 in my right front jeans pocket in a Sticky nylon holster...I know many folks don't care for pocket carry but it just works for me and the gun is...

Buying a Bull Two sisters - one blonde and one brunette - inherit the family ranch. Unfortunately after just a few years they are in financial...

I have i used it for a Glock 42 it's ok but is very slow to use. For me i found either a Maglulu or one made by Makershot does the trick

Yes I think the lakeline base plate would look better than the one that comes with S9 7 round mag. I'll try one with my Pm9 if I like it I'll make it...

BEST GUN SIGHTS EVER ?

I most commonly carry a S&W 642 in the right front pocket. Thin leather pocket holster and five spares on a speed strip for a reload. This is my...

1911 full size especially in cooler months, Commander in warmer months, PM 45 on ankle nearly always all months especially if I'm not supposed to...

Remembering that I have prototype parts, I'd say that yes you can use the OEM polymer base plate. It works with my PM9, but the mag just barely locks...

Uplula works well for me, but it is a bit chunky in my kit, so when I encountered this thread last month, I ordered a rangetray. Finally got around...