Activity Stream

Get yourself a Maglula mag loader. Saves the fingers for shooting.

Looks like you have a Pearce magazine baseplate there. I've put them on my CM9 magazines and can testify that they provide a noticeable improvement...

Yep on the sandpaper. It will feed into the chamber smoother then too. I did that to mine.

That's a good question. It's at least 10 years old. A few months ago I sent it back to Kahr and they replaced all the internals of the magazines. ...

Have you cleaned the mag since you bought it? Kahr uses some preservative that gets quite sticky as it ages. I would take it apart, clean it, and...

.......

:D:

My wife spent last weekend at her sisters to help her out after some minor surgery and when she walked in Sunday night she asked if I had missed her...

FOUND THIS IN MY WIFES DRESSER ALONG WITH A LARGE BOTTLE OF SLEEPING PILLS. SHOULD I BE CONCERNED ?

FOR LIBERALS ONLY...

Thank you Sir, I'll get them up to you sometime next week.

Congratulations! Glad to hear she’s running well for you!

Bacon... The Impossible Salad

I can do that, no problem. All I have are 20 line per inch cutters, hard to tell from the pic what the sides are checkered at, so it may or may not...

Hey Colonel, looking for some extra work? If so, would you be interested in adding some checkering to the backstrap of these?

Ball point pens that are all soft plastic work well as ramrods to free up stuck snap caps as well as the laser cartridge that Bird pictured. The...

I use those too in my 9mm and .380s. Joined up with this gem costs less than $100 total. The target stays right next to my TV but you can put it...

Kjorg, This is the type of laser trainer I have used for both my Kahr 9mm and 45 pistols. Cheap to practice with vs going to the range. The firing...

Yep

Based on this, it was very intentional. ...