View Full Version : problem mk9 returned already

12-29-2011, 06:06 PM
Got my mk9 back from Kahr after only 8 days. Paperwork says they installed a new triggerbar and test fired. Cocking cam for striker block does not come up above the frame rail as before I sent it to Kahr There is one thing I would like some opinions on. The trigger pivot pin is now not flush on the frame by just a little The right side (large end of pin) is out just a tad. Should I not worry about it ? I like all my guns to be rigjt Can a smith by me tap it in or can only Kahr press it in

12-29-2011, 07:06 PM
Should be easy to just tap that pin back in flush. I'd try a brass punch or even a wood dowel first and see how tight it is. Must not be too tight if it's backed out some. They may have removed it and didn't quite get it back flush too.

12-29-2011, 07:33 PM
I am going to test the gun at the range tomorrow. Sometimes there is a gunsmith there I think you're right on that when they put the pivot pin it wasn't pushed in far enough