ejecting magazines

[rss5995]

anyone else having problems with their polymer kahrs ejecting magazines? even the new metal magazine release mechanism does not seem to solve the problem. anyone know the solution?

[cmichael]

anyone else having problems with their polymer kahrs ejecting magazines? even the new metal magazine release mechanism does not seem to solve the problem. anyone know the solution?

I don't know, I have a K40 :D:D

[Dframe]

I don't know. I have never had this problem with my 40

[pudly]

No problem with my polymer CW9. Good luck. If you don't get an answer fairly soon, contact Kahr support and post any solutions that you find here for future reference.

[rss5995]

I don't know, I have a K40 :D:D

so do i. no issues ejecting mags with my steel gun, but still like the polys better.

[jocko]

kahr, my bet is you have a bad metal mag catch, it happens. get a new magazine catch spring to while ur at it.

You can google up kahr magazine catch installation also with compelte detaisl. If you hve a long nose se tof plies, it will take you maybe 5 minutes..

Also make sure you not accidentely hitting the mag release while shooting.. Eliminate the possables before calling kahr..

[mammynun]

My PM45 would drop the mag in about one of ten mags. I noticed that my mag catch did did not sit flush with the frame. I carefully filed down the side that seats inside the frame and it hasn't dropped a mag since. I didn't remove much, maybe 1/32" (I should have mic'd it) and it may well be that I was hitting the mag release. But it fixed the issue in my case.