PDA

View Full Version : The "Ghetto Mod" Pistol Grip



JCP281
04-08-2011, 06:40 AM
Hey guys, I did a short video on a simple mod I did that made my CW 100% better to shoot. A lot of you already know about it, but for those that dont its a cheap mod that WORKS.

http://www.youtube.com/watch?v=YZ3_RwUpmpk

Willieboy
04-10-2011, 10:51 AM
What size innertube did you buy?

wyntrout
04-10-2011, 12:30 PM
I used a 26x1.75 (1.75" diameter) tube and it fits all, including P380. Start with the largest gun and maybe a "mistake' will fit a smaller gun. :)

Don't forget there's talcum powder inside the tube! Don't cut the tube over your guns!

And, I've found that the tube grip looks better turned inside out and washed.

Allow clearance for the magazine release... both sides, and don't let it creep down and block the magazine well. Did all of those in testing. :D

I put them on all of my Kahr Tupperware... matched set. :D

Wynn

JCP281
04-11-2011, 07:23 AM
What size innertube did you buy?

I used a 20" diameter tube. they are pretty standardized in size when it comes to the actual air tube diameter so dont worry about all that.

I did turn the tube inside out though, and washed all the powder off.

I used a razor blade and cut around the magwell to make sure there was plenty of clearance.

Bawanna
04-11-2011, 09:22 AM
I left the powder, helped slide on a little easier. Once it was on it never moved. Fit pretty tight but worked real good.

Catshooter
04-11-2011, 12:29 PM
Bwanna,

You are talking about an inner tube on a Kahr, right?


Cat

MW surveyor
04-11-2011, 01:02 PM
Bill - if you read this, don't buy a tube! I've got two from the bike shop for free.

Bawanna
04-11-2011, 01:04 PM
Bwanna,

You are talking about an inner tube on a Kahr, right?


Cat

Umm, yeah.