Originally Posted by
guido4198
Since you already have two kits coming...I'll recommend that after you have fired a magazine, check the spring/follower relationship. The instructions that come with the kit require that you make sure the last coil on the cpring is in the little "notch" in the follower. I have been unable to keep the spring in the "notch" on the follower as the manufacturer's instructions require. It's in there when I load the mag, NOT in there when the mag is empty. Trying to shoot in that condition ( spring not in the notch) results in failure. I don't imagine the manufacturer's intention was that I have to re-set that spring/"follower notch" relationship everytime I load a magazine. I have sent an inquiry to them ( last week). It was just that...an inquiry, and request for assistance or guidance. Not some kind of rant, demand, etc. Still waiting to hear back from them.
At this point....I'm not terribly upset. I understand that sometimes new products have "issues" and am OK with working through them, IF the manufacturer is responsive and stands behind their product. I only posted my earlier comment in response to a post from someone getting ready to order in an effort to advise that things aren't all rosy with the 6+1 MagGuts 9mm kit and that perhaps folks might want to know how the company addresses problems, BEFORE ordering.
IMHO: the jury is still out. When this has either been resolved, or NOT...I will happily post a full report and let the chips fall where they may...good or bad.
'nuff said for now.