Kahr 380 Striker Ultimate Fix
Coming in January. What I refer to as a "Super Strength" striker and spacer. Here is a photo showing some of the differences in a plastic printed prototype:
https://lakelinellc.com/wp-content/u...on-700-pxl.jpg
The white, plastic part shows the new design above a factory part. First, the striker is much thicker in the area that they fracture. The spacer is thinner to keep the un-sprung travel the same. The material is heat treated S7 tool steel. That is about the toughest steel available for this type of part. Both the striker and spacer in our 380 Striker Solution are machined S7 tool steel. The body of the part is also slightly lengthened to keep the boss from hitting rounds in the magazine while the striker block spacing remains the same to the firing pin.
They are out being made now and will be available in January. You can dry fire this forever and the striker will not fail.
I have have been refining this design for quite awhile. I finally found a shop who can make it cost effectively too.
What do y'all think?