-
New pm9 barrel question
Is this typical wear after 300 rounds on a new pm9. The corners of the top of the barrel hood seem to be shaving. Emailed kahr 3 times since last Thursday and haven’t received response https://uploads.tapatalk-cdn.com/201...16638ac445.jpg
Sent from my iPhone using Tapatalk
-
That's a common wear area. I'd keep shooting and watch that area. If it continues to get worse or the gun fails to go into battery by a slight amount then it might need attention.
I had one that peened in that area and had to be replaced on a K40. Yours at least what I can see in the picture doesn't look bad enough to be a concern at this point.
-
Thanks for the advice it has functioned flawlessly and is my new favorite carry piece. The g43 went back in the safe. Hope it’s just a little break in and parts will mate and it wont peen any further
Sent from my iPhone using Tapatalk
-
The nickel plating flaking off, basically just cosmetic. Still wish Kahr would be more responsive to emails, sometimes they lack in customer service.
-
Not just plating moving metal too
Sent from my iPhone using Tapatalk