Search:

The first go around I left the spring stock and I could get the 5th round in (very tight) but you had to work to get the clip to seat, with 4 rounds the clip seated like factory. I then cut rounds...

Here are a few more angles:

https://i.imgur.com/vVbrEYj.jpg

https://i.imgur.com/tjNQvTU.jpg

https://i.imgur.com/mVQg5qV.jpg

https://i.imgur.com/3iKjSrC.jpg

Haha! I don't know about being sharked but I was hoping someone on here already had a "method" I could follow. I was a mechanic and a machinist for 20 years until my body said it wasn't hanging over...

Thank you sir! I do have access to a Zortrax M200 3D printer (I'm a Engineering/Technology teacher) so I may give some ABS plastic a shot. This is my first one and with any project the quality gets...

If I can get a decent order up I will be happy to do more.

Thanks, The first go around I left 1/16" sticking out but went back to the grinder and took it down just below flush...you do have to used your thumb to get the "click" but it works fine.

Ok....so I didn't get the response I was hoping for on this thread....so I took it upon myself to figure it out. I decided rather than get a 1911 mag and have to modify the feeder lips, I would just...

Looking for a flush fit magazine for my PM45, like this one http://www.kahrtalk.com/showthread.php?25077-CM45-Flush-magazine-I-made-one!

I contacted BearDog but haven't heard anything back, anyone...