Tommy Gun   Kahr Shop   Mitch Rosen   CrossBreed Holsters

Search:

Type: Posts; User: Marine One

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. OP it sounds like you have a built in excuse to...

    OP it sounds like you have a built in excuse to hit the range. Thinking about this, it could be any number of things, but none of which you could put your finger on, and none of which would cause me...
  2. Replies
    7
    Views
    2,938

    I've put Crimson Trace Laserguards on my three...

    I've put Crimson Trace Laserguards on my three Kahrs (CW380, CM9 & CM40), and have sighted them to where point of aim = point of impact at 7.5 yards. At that range I easily get nice tight groups...
  3. I'm sure there are some with much more experience...

    I'm sure there are some with much more experience than me who will chime in on this but FWIW, I am learning that with both my CM9 and CM40 that I get the best shooting experience with the standard...
  4. Replies
    11
    Views
    11,968

    Not sure the OP's issue is removal of the pin,...

    Not sure the OP's issue is removal of the pin, but that the slide won't come off after the pin has been removed. That was my issue at least.
  5. Replies
    11
    Views
    11,968

    I've had the same problem with my CM9 from time...

    I've had the same problem with my CM9 from time to time. It has never happened with my CM40 or my CW380. Last time it happened I put the pin back in, pulled the slide all to the way to the rear,...
  6. Replies
    16
    Views
    8,103

    I've done very well on gunbroker.com. Purchased...

    I've done very well on gunbroker.com. Purchased a CW380, CM9 and (2) CM40s there. All guns were new in box, all paperwork etc. Got the two CM40s for what I thought was dirt cheap. One was $265 and...
  7. Replies
    9
    Views
    4,694

    Had the same thing happen with my CM40, did the...

    Had the same thing happen with my CM40, did the feed ramp shave thing CJB mentioned above using some 320/400/600 grit sandpaper. There are several other posts and a youtube out on this fix as well. ...
  8. Replies
    18
    Views
    9,127

    In the beginning I was rotating the three mags so...

    In the beginning I was rotating the three mags so I wasn't tired yet. I'd load all three, shoot the two five round mags then the 6round mag, then reload all three. I stopped using the 6 round mag...
  9. Replies
    18
    Views
    9,127

    WMD, Thanks. Certainly some things to look at...

    WMD, Thanks. Certainly some things to look at next time at the range. I've been pretty consistent and careful with the grip, particularly after having the issue the first trip out with the 40, as I...
  10. Replies
    18
    Views
    9,127

    Follow-up

    The new spring and mag follower arrived a few days after my call to Kahr. I finally just got to the range today. I'm confident to say that the problem is conditionally resolved. The condition is...
  11. Replies
    25
    Views
    14,515

    In 30 years in the Corps I managed to get back...

    In 30 years in the Corps I managed to get back from two deployments to Iraq and one to Desert Storm without so much as a sprained ankle. Not going to lose my life to some thug who thinks I am an...
  12. Replies
    18
    Views
    9,127

    Yep,that would be me, the bitching Marine, just...

    Yep,that would be me, the bitching Marine, just ask my Wife! When I took the weapon to the range for the initial 200 round break in, it ran just fine for the first 50 or so rounds, which is part of...
  13. Replies
    18
    Views
    9,127

    Interesting. Now that you mention it, I had a...

    Interesting. Now that you mention it, I had a hell of a time getting the slide stop pin out of this weapon as well. I had no problems getting the pins out of the CW380 I purchased last June and the...
  14. Replies
    18
    Views
    9,127

    Just got of the phone with Kahr. Was essentially...

    Just got of the phone with Kahr. Was essentially told that I must have buggered up the slide stop spring when reassembling the weapon. I told the rep I would be surprised if I caused it as I have...
  15. Replies
    18
    Views
    9,127

    Thanks for that info. It is timely as I put...

    Thanks for that info. It is timely as I put another 136 rounds through it today with no improvement on the slide locking problem. I did not experience any problem with the slide not returning to...
  16. Replies
    18
    Views
    9,127

    Update: Disassembled and cleaned the pistol. It...

    Update: Disassembled and cleaned the pistol. It was considerably dirtier than I remember the CM9 being after cycling through 200 rounds in one afternoon. Also disassembled and cleaned the 3 mags. ...
  17. Replies
    18
    Views
    9,127

    Thanks FelixD. Plan is to go back to the range...

    Thanks FelixD. Plan is to go back to the range with another box of each ammo either tomorrow or the next day and do some experimenting on whether the ammo makes any difference. I dry fired the...
  18. Replies
    18
    Views
    9,127

    Yeah I re-read the how to prep a Kahr sticky. ...

    Yeah I re-read the how to prep a Kahr sticky. Need to go back and see if it's my thumb but I really doubt it. Hasn't been an issue with my CM9 or CW380. Need to clean, relube and get another box...
  19. Replies
    18
    Views
    9,127

    CM40 Range Report-2 Issues

    Took my new CM40 to the range for the 200 round break in today. I had one 100 round box of Winchester White Box, a 100 round box of Federal ammo, 2 five-round magazines and 1 six-round mag.
    I...
  20. I love my CW380. Have 500+ round through it and...

    I love my CW380. Have 500+ round through it and it has been completely trouble free. It is very accurate and easy to pocket carry concealed.
  21. Another Kahr; Is This Becoming an Addiction?

    Just took delivery of a new CM40 on Friday. Purchased a CM9 last October and a CW380 last June. Some wives don't let their husbands surf porn sites or go to gentleman's clubs. Mine doesn't let me...
  22. Thread: Ebay snipe

    by Marine One
    Replies
    29
    Views
    10,757

    I own a 30 foot cabin cruiser that is 15 year...

    I own a 30 foot cabin cruiser that is 15 year old. Ebay has been a godsend for reasonably priced parts and accessories. I can get name brand parts for much less than at someplace like West Marine....
  23. Replies
    19
    Views
    9,727

    Interesting concept. I've an experience that...

    Interesting concept. I've an experience that might be beneficial to add. I wear monovision contact lenses. They are set up in such a way that my dominant eye is used for distance. I'm right handed...
  24. Replies
    24
    Views
    9,357

    Back to the range today. Happy to report all is...

    Back to the range today. Happy to report all is well. 100 rounds through the CM9 and no problems. Thanks for not rubbing my nose into it too far....
  25. Replies
    24
    Views
    9,357

    Yes, probably won't make that mistake again! Was...

    Yes, probably won't make that mistake again! Was on the range with both Kahrs (CW380 and CM9) before Christmas. Got running late and the wrong stuff got in the wrong box Yesterday it got into the...
Results 1 to 25 of 57
Page 1 of 3 1 2 3
Crimsontrace   Tommy Gun Shop   Xssights   Magnum Research new