CrossBreed Holsters   Tommy Gun Shop   Xssights   Magnum Research new

Search:

Type: Posts; User: SKSears

Search: Search took 0.00 seconds.

  1. Replies
    17
    Views
    3,706

    It took about 6 weeks for the PM45 to make it...

    It took about 6 weeks for the PM45 to make it back from Kahr customer service. Had a couple of FTF during the first mag. After those initial problems it has been functioning with no problems! Action...
  2. Replies
    17
    Views
    3,706

    Good news & bad news. Made it to the range today....

    Good news & bad news. Made it to the range today. 150 rounds thru the P380 with zero problems! 100 rounds thru the PM9 ,zero problems. Bad news is PM45 is still jamming. The striker not resetting....
  3. Replies
    17
    Views
    3,706

    Greg, Iíve been playing with this PM45 off & on...

    Greg, Iíve been playing with this PM45 off & on for a few days and think you might be right about the stricker block being the problem. How big a deal is it to remove & change out. I was thinking of...
  4. Replies
    17
    Views
    3,706

    Greg ,I hope to have time tomorrow to work on...

    Greg ,I hope to have time tomorrow to work on this and see if that fix you referred to might take care of this. Thanks for your time & you welcoming me to the forum, Sears.
  5. Replies
    17
    Views
    3,706

    Greg, as far as my brothers PM45, after the...

    Greg, as far as my brothers PM45, after the jamming started I did completely break the slide down and clean, leaving striker channel dry , reassembled & lubed at recommended points ,fired the gun...
  6. Replies
    17
    Views
    3,706

    Greg, I did not try pushing the striker back in...

    Greg, I did not try pushing the striker back in but I did turn the gun over and pulled it back by the tab below the slide.with the P380, I just dry fired and pulled the slide to the rear locking it...
  7. Replies
    17
    Views
    3,706

    Greg, Iíll try an explain this as best I can....

    Greg, Iíll try an explain this as best I can. After firing the last round in the magazine, the slide travels to the rear & locks back. At this point the striker to protruding from the breach face....
  8. Replies
    17
    Views
    3,706

    I talked with a service tech. at Kahr and...

    I talked with a service tech. at Kahr and explained in detail what the PM45 was doing and he said to send it to them to be checked out. As far as it retracting during the cycle forward, it is not in...
  9. Replies
    17
    Views
    3,706

    Striker not resetting after firing ?

    My brother and I recently purchased 3 Kahrs. He a PM45, & I a PM9 & P380. My PM9 ran flawlessly for 250 rounds. My brothers PM45 ran fine using the 5 round Mags but persistent jamming with the 6...
  10. Replies
    162
    Views
    74,776

    Sticky: SB34xx - P45 - March 2015 . Date was obtained via...

    SB34xx - P45 - March 2015 . Date was obtained via email from Kahr. I'm a new member. This my first post.
Results 1 to 10 of 10
Tommy Gun   Mitch Rosen   Crimsontrace   Kahr Shop