Crimsontrace   CrossBreed Holsters   Xssights   Tommy Gun

Search:

Type: Posts; User: guido4198

Page 1 of 10 1 2 3 4

Search: Search took 1.17 seconds.

  1. Thread: CW9 or P365

    by guido4198
    Replies
    10
    Views
    1,805

    I've been carrying my Kahr CM9 with a few modest...

    I've been carrying my Kahr CM9 with a few modest aftermarket modifications since 2013. Very satisfied. With my "aging eyes" vision issues ( I'm 72) I decided to try a new pistol for EDC so I picked...
  2. Replies
    16
    Views
    4,611

    Looks like you have a Pearce magazine baseplate...

    Looks like you have a Pearce magazine baseplate there. I've put them on my CM9 magazines and can testify that they provide a noticeable improvement in how well I shoot the little gun, without...
  3. Replies
    19
    Views
    2,268

    That's a 10" .41 mag. I load with 200 gn bullets...

    That's a 10" .41 mag. I load with 200 gn bullets and relatively fast powders. It will shoot ragged one hole groups off a rest out to 50 yds, which is about as far as I have ever needed to go where I...
  4. Replies
    19
    Views
    2,268

    I agree Dao. The ten rd would obviously be for “...

    I agree Dao. The ten rd would obviously be for “ backup” and at that point… we’re waaayyy past being concerned about appeance or concealment. On the red dot… I’ve used them very successfully on a...
  5. Replies
    19
    Views
    2,268

    I can't imagine anyone finding a hideous 10 rd...

    I can't imagine anyone finding a hideous 10 rd single stack mag in their Kahr to be a good idea. Almost feels like an "inside joke" aimed at the folks who demand more rounds.
    I upgraded my CM9 with...
  6. Thread: New member

    by guido4198
    Replies
    6
    Views
    1,569

    Welcome Arreaux..! Tell us about your K9. Jeep...

    Welcome Arreaux..! Tell us about your K9. Jeep and dao might want to petition for a new sub-forum.."All Critters Great and Small" :rolleyes:!
  7. Replies
    33
    Views
    4,265

    If anyone has been following my thread in the...

    If anyone has been following my thread in the "Other firearms" section you'll notice that my interest in the Sig P365 wasn't driven by a desire for more rounds. I put the MagGuts +1 in the 6rd Kahr...
  8. Replies
    30
    Views
    4,744

    In the interest of clarity...I have edited my...

    In the interest of clarity...I have edited my original post. The Sig I have recently acquired is the P365 X. I doubt if I'll order the Wilson unit for it. I'll give the Hogue sleeve a try, for...
  9. Replies
    30
    Views
    4,744

    Anyone tried the Hogue beaver tail grip sleeve on...

    Anyone tried the Hogue beaver tail grip sleeve on a P365x..??
  10. Replies
    30
    Views
    4,744

    Mine came with the factory flat trigger. I've...

    Mine came with the factory flat trigger. I've been carrying my CM9 with Galloway flat trigger for several years now and like it fine. I'm going to contact them about the trigger they offer for the...
  11. Replies
    30
    Views
    4,744

    I'm not one who believes in "leaving it alone"...

    I'm not one who believes in "leaving it alone" when it comes to tools that can be improved to make them more efficient or more effective for their intended purpose.
    I've made several improvements...
  12. Replies
    13
    Views
    3,158

    I've been carrying my CM9, OWB in a Don Hume JIT...

    I've been carrying my CM9, OWB in a Don Hume JIT holster for several years and REALLY like it that way. Mine rides about halfway between 12 and 3 on my waist (I'm left-handed).
  13. Replies
    30
    Views
    4,744

    Since some have asked, here's a few first...

    Since some have asked, here's a few first impressions after one range session and a good bit of dry draw-fire practice around the house:
    1. The gun feels good in the hand
    2. This was a new, unfired...
  14. Replies
    30
    Views
    4,744

    I've joined the P365 club.

    I joined this forum in 2011. I acquired my Kahr CM9 in 2013 and have used it for EDC ever since. At 72 yrs old, my vision isn't good enough to use iron sights for any kind of precision shooting while...
  15. Replies
    142
    Views
    16,550

    BINGO...!!!!! I grew up in Ft. Lauderdale, FL....

    BINGO...!!!!!
    I grew up in Ft. Lauderdale, FL. I'm outta there now, living in very nice small town about 125 mi up the coast. I still get back there from time to time, and sometimes drive by my old...
  16. Replies
    24
    Views
    6,442

    I've had no problems with Federal HST 124 gn...

    I've had no problems with Federal HST 124 gn loads. Just to add another one, I've also had no issues with Sig "V-Crown" 115 gn. JHP rounds, "optimized for CCW". (per Sig)
  17. Replies
    22
    Views
    4,713

    Snowbird, Following this thread, I see that...

    Snowbird,
    Following this thread, I see that you've decided to send your pistol in to Kahr. At the moment, that's probably the best plan. Let us know how it goes.
    For future reference, if you...
  18. Thread: Joe Biden

    by guido4198
    Replies
    29
    Views
    3,815

    FJB. That's all I'm gonna say.

    FJB.
    That's all I'm gonna say.
  19. Replies
    12
    Views
    1,904

    I've been handling and shooting a pretty wide...

    I've been handling and shooting a pretty wide variety of "carry guns w/ red dots". Haven't found a gun that I prefer over my CM9, which is why I've asked about just cutting the gun I already have,...
  20. Replies
    12
    Views
    1,904

    Anyone cut a slide..??

    I'll be 72 next month. My EDC gun is a CM9. Love it. I've been looking at and test firing other EDC options with itty-bitty red dots mounted on them.
    Has anyone had the slide cut on one of the...
  21. Replies
    142
    Views
    11,476

    Bird... That Hogue you installed really looks...

    Bird...
    That Hogue you installed really looks great. Does the "beavertail" take up grip space that results in your hold being lower on the grip and increasing the perceived muzzle flip..??
    How is...
  22. Thread: Taurus GX4

    by guido4198
    Replies
    82
    Views
    15,540

    Thanks for the comprehensive review and comments....

    Thanks for the comprehensive review and comments. I've had the same "trigger finger discomfort" you describe, when running large amounts of ammo through my Glock in a single range session. Doesn't...
  23. Thread: Taurus GX4

    by guido4198
    Replies
    82
    Views
    15,540

    Thanks...I just found out that is an option. ...

    Thanks...I just found out that is an option.
    I'll be keeping my eyes open to get my hands on one and give it a real hard look.
  24. Thread: Taurus GX4

    by guido4198
    Replies
    82
    Views
    15,540

    Nice to see new offerings. I keep reading about...

    Nice to see new offerings. I keep reading about quality improvements in Taurus firearms which is great. When I started getting serious about defensive handguns...in the mid 1970's...Taurus wasn't a...
  25. Replies
    142
    Views
    11,476

    Interesting topic. If I understand...

    Interesting topic. If I understand correctly...Not a discussion of current preferred caliber per se, but have we changed our decision.
    I have. For a very long time, IMHO I considered 45acp in a Colt...
Results 1 to 25 of 235
Page 1 of 10 1 2 3 4
Tommy Gun Shop   Magnum Research new   Kahr Shop   Mitch Rosen