Not acceptable solution in my opinion. The lower should be replaced! That's what I want.
Not acceptable solution in my opinion. The lower should be replaced! That's what I want.
totally unacceptable. The entire gun should go back. You should recallthem and ask for IAN and send him that photo by email etc, . You should not hav eto pay to send it back. They should issue a pre paid pickup on that gun. You should insist on it to. or otherwise you will be out about $40 for shipping over night to them.
In this case especially, this is a total defective gun and they shold bare the brunt of paying shipping both ways. Its your call, but I certainly would not take no for an answer either... As they will pay to pick it up but certainly volunteer it either.. You need to talk to the right person to..
Last two times out with my PM45 I noticed some small black shards... very small ... on my forearm. At first I thought that it was just powder (the Federal 230gr FMJ seems to run pretty dirty), but after reading this thread I wonder whether it could be from the polymer. Will take a magnifying glass once I take it down and see whether it could be polymer shards and report if I see a problem.
I hear ya...Actually it is Ian who I was in email contact with...Sent him the photo I've attached here as well. Initial response was that this is the way it was machined...But I replied that this is certainly not machined due to the roughness. But totally quick replies, and promptly got an RA# from them. Not too worried about the shipping cost, just want this brand new piece to be correct! I'm certainly not firing this thing again until they check it out. Not sure, but I'm betting it's somehow coming into contact with the spring, and that is not a good thing.
elars2
PM sent.
I feel your pain.
I had a chip of metal come off after 200 rds.
sent it back to Kahr. They said they replaced the barrel but the barrel that came back with it has this corner rounded off.
Sure looks like it was polished out instead of being replaced.
I will be calling Kahr next week.
Here is another view.