I purchased a CW40 in the Fall of 2012. I have put approximately 300
rounds through it and have had two issues arise. Apparently everyone has had the bent/broken slide stop spring, a probelm which I have solved. However, no I am unable tochamber a round; regardless of how I attept to do so. I have tried loading a magazine and dropping the slide with the slide stop, but the slide sticks back about 1/4" from being fully chambered. I am using the factory magazine, and there are no obvious obstructions/protruding
objects. It is not an ammo issue as I am unable to chamber a round in the first place.

Any suggestions on what is going wrong? I have contacted Kahr Service, and they are sending me a new recoil spring, but I can't see how this is going to slove the problem.

Thanks,