As I posted above, I installed the Kahr (Tirjicon) night sights on the CM40.
Took it to the range.
The front sight was installed as per instructions:
Red Locktite in the threaded (rear) hole. Hand tightened. Allowed to cure 24 hours.

So, the thing I notice is that there is a slight wobble in the FRONT of the front sight - the rear of the sight is held by the screw, and is quite solid. The screw is in there real good, not loose at all.

But in the front area, where the second "tube" is located, there is a small amount of lateral movement. This does not seem right, yet the front tube is not fastened in any way.

The sight did not come flying out, and did not get any "looser". This appears simply to be the "play" in the hole between the stud and the hole.

Any ideas how to make this more solid? This may simply be a design issue that can not be cured.

I am tempted to try to stake it using a punch, but probably will do more damage than good.