got it today. model 18000 handall jr.. will install it tomorrow. Update after the 1st range trip with it on
got it today. model 18000 handall jr.. will install it tomorrow. Update after the 1st range trip with it on
grip went on no problem, maybe 10 minutes. feels great
I started with that, went over to the Talon rubber grip.
Draw me not without provocation, sheath me not without honor.
I'm not a big fan of slip on grips. Be careful that yours doesn't slip up and cover the right side of the mag release. It could prove embarrassing in a gun fight. I went to the decal style grip.
Never trust anyone who doesn't trust you to own a gun.
Life Member - NRA
Colt Gold Cup 70 series
Colt Woodsman
Ruger Mark III .22-45
Kahr CM9
Kahr P380
It fits my CT45 too
I came across this old thread as I was searching for a Hogue grip with beavertail for a CW45. Apparently it does not exist. Looks like I may go this route. Thanks Shlike!
I believe the vearvertail grip you are seeking is the one for the S&W Shield 45. The website lists it for the p9 and p40, and I would assume that the Shield 45 is a bit thicker than the CW45. Personally, I don't like them on my Kahrs, but use a non beavertail version on another firearm.