Mitch Rosen   CrossBreed Holsters   Tommy Gun Shop   Magnum Research new
Page 2 of 2 FirstFirst 12
Results 11 to 15 of 15

Thread: Replacement sights for US made DE .50AE with 8-slot rail?

  1. #11
    Join Date
    Jan 2020
    Location
    lockhart, texas
    Posts
    32

    Default

    Exactly my situation with the Williams Firesights too, MrBlackCat. I had the rear sight all the way down, and still was shooting high at 25 yards. I called Dawson Precison, explained the situation, and he told me his formula for finding the correct height for the front sight. I gave him my measurements, and my credit card number, and he made me the correct front sight. I installed it as soon as i got it, went to the range and actually had to come up about 4 clicks to get it dead on at 25 yards. The Williams rear sight worked perfect with the Dawson front sight. But, as I said in a previous post, I put a scope on it soon after. My 74 year old eyes work much better with an optic.

  2. #12
    Join Date
    Oct 2020
    Posts
    3

    Default

    New here and just ordered my first DE but I use this sight on almost every gun I have. I am also going to be milling one of these to work on my Jericho 941. Eventually I might have my other Jericho milled with an optic cut now that CZ is doing it.

    On to the sight which is a https://www.seeallopensight.com/ and while it does take a little while to get used to that is no different than with a red dot. These are a LOT cheaper, no batteries, no electronics, lifetime warranty, and you could drop a DE on top of it and not break it.

  3. #13
    Join Date
    Jan 2020
    Location
    lockhart, texas
    Posts
    32

    Default

    Well, good luck with your sight, I put a Tru-glow red dot on my .50AE, and it lasted all of THREE shots before disintegrating before my eyes! That's why I went with a Bushnell 2x scope. Hundreds of rounds later, still going strong.

  4. #14

    Default

    There are these new Tritium Sights on Kahrís website...

    Not sure what theyíre cut for.

  5. #15

    Default

    In the pre - stainless Mark XIXs, there are actually two different front sight heights, and they donít make the older ones anymore.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Crimsontrace   Tommy Gun   Kahr Shop   Xssights