Lakeland followers

[Romadoc]

Is there any video clip showing how to install a new Lakeland follower? I want to know if it is beyond my capabilities before ordering.

[shlike]

Is there any video clip showing how to install a new Lakeland follower? I want to know if it is beyond my capabilities before ordering.

You simply disassemble the magazine and drop in the Lakeline follower (exactly the same as if you were putting the OEM follower back in). Put the spring back in and the base plate back on and you are done. It's really as simple as that. It goes in exactly the same as the OEM follower. The owners manual that comes with your Kahr has a section that describes (with photos) how to disassemble the magazine. The Lakeline followers also come with instructions. It takes all of 30 seconds to do. Easy-Peasy.

[yqtszhj]

Its a piece of cake. Slide the bottom off the mag, take out the old one, put in the new one, and your done. There's no special tools or little springs to get lost.

[b4uqzme]

You can find anything on youtube.

https://m.youtube.com/watch?v=RvR2T0hwUbc

[MikeAvery71]

Easy. Took me about 2 minutes to install the first one, and I was worried it would be difficult to compress the spring. It wasn't bad at all.

[Romadoc]

Thanks to all who responded. Change of followers went very easily. Thanks again!

[Geo]

Are they better than the OEM followers?

If so, what is better about them?

i just got my Plain Jane K9, and am looking to replace the guide post and sight ...

...would like to me to know more about these followers.

Hope to get to the range tomorrow to start wringing it out.

Thanks to All for the good information posted here!