Wondering if anyone else has done this to their CM9 mag?

I never cared for the look of that flat metal base plate on the factory 6 round magazine so I took the base plate off of a 7-round magazine and only had to sand a very small amount off the the top edge of the plate so it would let the mag go in slightly further so the mag catch could engage the hole.

I then used one of those magazine filler sleeves on the 7rd mag which fills the Gap if using a 8-round magazine in the CW grip or using the 7-round magazine in the CM grip...

I can't seem to find a way to upload a photo saved on my phone.