CrossBreed Holsters   Crimsontrace   Mitch Rosen   Magnum Research new
Results 1 to 3 of 3

Thread: finely fired my new pm 40

  1. #1
    Join Date
    Dec 2017
    Location
    ohio
    Posts
    53

    Default finely fired my new pm 40

    400 rounds mixed ammo jhp and fmj never missed a beat I was very impressed the follower on the 5 rnd mag broke off on were the spring goes in but it still works any ideas on what to do call kahr for a new follower or get a after market

  2. #2
    Join Date
    Jan 2010
    Location
    Near the Gila Mountains in SW AZ.
    Posts
    5,550

    Default

    Quote Originally Posted by mattallamerican View Post
    400 rounds mixed ammo jhp and fmj never missed a beat I was very impressed the follower on the 5 rnd mag broke off on were the spring goes in but it still works any ideas on what to do call kahr for a new follower or get a after market
    I'm a fan of Lakeline LLC's follower. It's made of aluminum and that should prevent the follower skirt from breaking off.

    However, the likely cause of the OEM follower failure was the barrel's feed ramp striking it. Unless that is corrected, it will still hit the Lakeline follower which result in some damage to the follower: http://www.kahrtalk.com/showthread.p...does-this-work
    Experience has shown that the Lakeline follower will continue to function in this condition, though I wold suggest a little clean up of any burrs that might occur.

    I recent bought a used P40 Covert that had a broken follower in the magazine that came with it. When I got it home I verified that the barrel's ramp would indeed make contact with the follower (especially the bottom left of the feed ramp). I removed material from that area of the feed ramp until I was satisfied it would no longer hit the follower. I then just blended that area with the rest of the feed ramp. I've put about 150 rounds through the P40 since then and my followers are intact, the pistol cycled without issue, and I can pretty much ride the slide all the way home when chambering a round.





    Kahr has been known to rework the feed ramp on pistols sent back to them for breaking followers.

    Regards,
    Greg
    Last edited by gb6491; 01-22-2018 at 09:03 AM.
    [<a href=http://i43.tinypic.com/2n7fnux.gif target=_blank>http://i43.tinypic.com/2n7fnux.gif</a>

  3. #3
    Join Date
    Dec 2017
    Location
    ohio
    Posts
    53

    Default

    thanks I bet that's the problem

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Tommy Gun   Tommy Gun Shop   Xssights   Kahr Shop