Originally Posted by
Ed M
This has been an interesting thread, to say the least.
Thanks to some fine detective work by markman, the root cause of many Kahr 380 feed problems may have been identified.
It'd be a lot easier to identify "problem" guns during the assembly process by simply measuring the extractor tension.
Kahr could easily set up a measuring system, and use it for both the initial assembly process, and also for their repair system process.
Certainly would be easier to modify the rear pin, than messing with extractor dimensions.
Perhaps Kahr should be made aware of this information - it might save a lot of headaches for both customers and Kahr themselves.