Magnum Research new   Tommy Gun   Xssights   Mitch Rosen
Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Still a bear to rack.....but perfection in performance

  1. #11
    Join Date
    Jan 2016
    Location
    wisconsin
    Posts
    412

    Default

    May be the recoil spring alignment rod is a little bit too large in diameter and creating friction. Did you change that to when you swapped springs with your friend? I ran some 900 wet and dry over all my sliding parts, including the plastic and use gun grease on all the sliding parts includeing barrel and inside of the slide under the barrel. My cm380 is stiff, but manageable. I use the technique of pushing the gun into the slide instead of pulling the slide back on the gun. My hand on the slide has my thumb pointing away from the front end of the slide. It just seems that you should be able to reduce the friction to the same level as your friends gun.

  2. #12
    Join Date
    Sep 2009
    Location
    Indiana
    Posts
    373

    Default

    My CW380 is still a ***** to rack after 500 rds or more. However, I've had zero issues so I guess it's a keeper!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Tommy Gun Shop   Kahr Shop   Crimsontrace   CrossBreed Holsters