Hey Guys,
So I lined up the markers with the frame and slide and I cannot for the life of me get that pin to push through...I'd tried pushing it with a few things and no luck. Any tips?
Hey Guys,
So I lined up the markers with the frame and slide and I cannot for the life of me get that pin to push through...I'd tried pushing it with a few things and no luck. Any tips?
I line up the marks or that back of the take down lever which puts it in the same spot and then tap it with a soft face hammer.
A screw driver handle or just about anything. It's just that initial little bit that's hard getting it past the spring and then its easy.
Mine is very difficult to just push, I can do it but a little tap is easier.
Give it a try and get back to us.
In Memory of Paul "Dietrich" Stines.
Dad: Say something nice to your cousin Shirley
Dietrich: For a fat girl you sure don't sweat much.
Cue sound of Head slap.
RIP Muggsy & TMan
"If you are a warrior legally authorized to carry a weapon and you step outside without that weapon, then you become a sheep, pretending that JOCKO will not come today."
Use a Sharpie marker.
Hold the gun horizontally and put the concave tip of the Sharpie on the round end of the slide stop.
While keeping slight downward pressure on the gun so the marker doesn't slip off, align the witness marks on the slide and frame.
Push down on the gun and the Sharpie will push out the slide stop enough to get it started.
I use a gun cleaning mat to help hold the marker in place while I line up the witness marks.
After ,you get the slide stop out, lube up the shaft and run a q-tip saturated with lube through the holes in the frame that the slide stop goes through.
After a few times of using the Sharpie trick, you'll be able to get the slide stop started with a fingertip.
One more thing, make sure you reinstall the lever correctly with the spring on top of the take down lever.
"Never pet a burning dog"
It is a bear until the gun loosens up. I hold it in one hand gripping Frame with slide pulled back. With the other hand push a pencil (eraser end) against slide stop. It should push out enough to pull it out on other side.