Perhaps just friends with benefits?Originally Posted by berettabone
Are they married, or just dating????????????
Colonel
Perhaps just friends with benefits?Are they married, or just dating????????????
In Memory of Paul "Dietrich" Stines.
Dad: Say something nice to your cousin Shirley
Dietrich: For a fat girl you sure don't sweat much.
Cue sound of Head slap.
RIP Muggsy & TMan
"If you are a warrior legally authorized to carry a weapon and you step outside without that weapon, then you become a sheep, pretending that JOCKO will not come today."
KahrTalk 1K Member
Strangers. The little one's sick and the big one is pushing her to the hospital.
KahrTalk 1K Member
Heard from Bird, he's doing fine. Just busy with life.
Senior Member
Thank you!!!!
KahrTalk 1K Member
Hey Colonel, looking for some extra work? If so, would you be interested in adding some checkering to the backstrap of these?
Colonel
I can do that, no problem. All I have are 20 line per inch cutters, hard to tell from the pic what the sides are checkered at, so it may or may not match perfectly but should still work fine if it close which it should be.
In Memory of Paul "Dietrich" Stines.
Dad: Say something nice to your cousin Shirley
Dietrich: For a fat girl you sure don't sweat much.
Cue sound of Head slap.
RIP Muggsy & TMan
"If you are a warrior legally authorized to carry a weapon and you step outside without that weapon, then you become a sheep, pretending that JOCKO will not come today."
KahrTalk 1K Member
Thank you Sir, I'll get them up to you sometime next week.
KahrTalk 1K Member
Comin along. I've spent 5 or 6 hours total sanding and polishing so far I think. Probably would have been time better spent learning how to take decent pictures.
I've also swapped out the controls and backstrap for stainless versions. Bottom pic is how it came to me.
KahrTalk 1K Member
She’s lookin great DAO!
KahrTalk 1K Member
Coming from you Bird that means a lot.
I've learned that the slide is not perfectly flat in the center between the bottom and where the round starts. There's an area on each side that I've had a hard time getting to. It looks like what you've described as chatter marks. The center of the slide where they reside is somewhat concave between the bottom and the round and so block sanding wasn't getting it done. I got most of it out of one side today by sanding with the edge of my block as it rode on only either the top of the bottom. A few more sessions and I should have it all out.
So far it's all been done by hand. I don't know if I'll use my buffer because I'm not sure how far I want to take this given that I'm only doing the flats of the slide. If I can get that last bit of chattering out I'll probably wrap it up with 2000gr paper and call it purdy.
Posting Permissions
Reply With Quote