Will Kahr stay in 1999?

[DJK11]

Omega! Too bad. Just polish it and pray.

[JohnR]

Omega! Too bad. Just polish it and pray.

Why is that? A spring won’t lighten it?

[DJK11]

Omega the CZ stepchild

[JohnR]

I see it was just discontinued, but can’t find why. https://cz-usa.com/product/cz-75-b-ω-convertible-omega/

All I want to do is lighten the trigger pull, not attend family reunions

[gb6491]

I see it was just discontinued, but can’t find why. https://cz-usa.com/product/cz-75-b-ω-convertible-omega/

All I want to do is lighten the trigger pull, not attend family reunions

Well shoot, I forgot about my P-09: which has the Omega trigger. The parts are bit different from the steel frame guns, but I believe the system works the same.
I did the polish on it and went with a lighter hammer spring. CGW says to use a lighter firing pin spring with the lighter hammer spring. I did that and also installed an extended firing pin (and spring steel firing pin retaining pin). As I had the slide apart, I used their reduced power plunger spring as well. There was enough improvement that I didn't feel enough need to use the CGW hammer. FWIW, I run my P-09 as a de-cocker.
Regards,
Greg

[DJK11]

I see it was just discontinued, but can’t find why. https://cz-usa.com/product/cz-75-b-ω-convertible-omega/

All I want to do is lighten the trigger pull, not attend family reunions

I’m a bit confused. You can work on and modify the mighty LCP but you are hesitant to do the same to a CZ? I assume the Omega was discontinued because the factory couldn’t keep up production given the demand. Maybe the same with Kahr with the S series.

[yqtszhj]

So just one $7 spring is allI need? I think I can manage that. I don’t mind polishing stuff as long as it’s clear exactly what and where to polish. I’ll search for tutorials. Ah: https://cdn1.cajungunworks.com/wp-co...-Polishing.pdf

Yep, that’s about it to lighten it up. You can change out the springs easily. The Omega will smooth out too with a little polishing. Not as nicely as the original trigger but still OK. Greg gave a good recommendation on the springs to change. You can do those easily with only a set of punches.

[JohnR]

LCP? Someone else? I’ve done lots of spring changes in semis and revolvers, I just wondered how many of the CZ’s springs affected to trigger weight. I’m ordering a couple blue springs now.

[yqtszhj]

You’ll like the improvement. It will make a nice difference.