I'll second that. That's an incredible smart solution.
I got a whole drawer full of used up dremel bits.
I'll second that. That's an incredible smart solution.
I got a whole drawer full of used up dremel bits.
In Memory of Paul "Dietrich" Stines.
Dad: Say something nice to your cousin Shirley
Dietrich: For a fat girl you sure don't sweat much.
Cue sound of Head slap.
RIP Muggsy & TMan
"If you are a warrior legally authorized to carry a weapon and you step outside without that weapon, then you become a sheep, pretending that JOCKO will not come today."
Thanks for the info Greg. I ordered two from Kahr yesterday as I needed to order some recoil springs and a few other parts.
There's a potential issue with this though. In my P380 the total stack of the back pin, the spring, and the front pin is 1.878" (with no compression of the spring.) The total in my CW380 is 1.913. Not much difference BUT, in the P the back pin is .520" and the CW it's .439. The spring is .648 in the P and .764 in the CW. I'm wondering if it makes sense to cut the back pin length to make the total stack something in that 1.878-1.913 range? BTW I was having extractor issues in the CW380 and reduced the back pin length .020 to reduce the spring tension a little. It runs fine now.
skiflydive,
It's good that you brought that up
I remember a member writing that he had done as you have, shortening the rear pin, to get his CW45 working correctly.
By making your own rear pins: you can experiment to see what works best in your own particular pistol.
Regards,
Greg
Ok I tried removing the extractor then the pin and the spring.
That went well however the pin in the back plate will not move.
Lite tapping does no good...am I screwed? Used cm9 functions
Perfect or did.
If you are trying to depress the pin through the opening in the back plate, look closely at the opening. The hole that extends to the pin is smaller than the opening in the plate. Greg posted some pictures around here somewhere.
Kahr P380 x2
Kahr K9
Kahr CM45
Sig P938
Sig P365 x2
Sig P322
1911 Range Officer 9mm
M&P 9mm
I want to be Greg when I grow up. Live near the desert, have a cool old jeep, be a master tinkerer, and the ability to post a pictorial explanation at the speed of a bullet.
The only thing better than having all the guns and ammo you'd ever need would be being able to shoot it all off the back porch.
Want to see what will be the end of our country as we know it???
Visit here:
http://www.usdebtclock.org/