Cobbling

[jmikesteen]

http://i34.photobucket.com/albums/d121/jmikesteen/temporary_zps3068d0b0.jpgI hate to be a bother but I need some info. 1st I don't know anything about Kahr weapons or their magazines. I started off by seeing that peirce grips offered a finger extension for a 6 round Kahr that fit a Colt Pocket nine. I have been looking for a way to get more than 6 rounds in my Pocket nine for years so I bought a 7 round promag as a low cost way to experiment. It fit and all I had to do was cut the mag catch hole up 1/8 of an inch. So then I bought 2 8 round Kahr mags with the filler on the bottom. then I bought this A&G grip extension labeled PM9/P9 and after a little dremmeling it's a perfect fit. Now the question if you haven't fallen asleep. what is the difference in size for the PM9/P9 that I got and the MK9/K9 that A&G makes? Thanks in advance if you have time.
http://i34.photobucket.com/albums/d121/jmikesteen/temporary_zpsd8a16da3.jpg

[gb6491]

Nice looking Colt!
Kahr 9mm magazines are all the same size except in regards to capacity (butt plates are interchangeable as well)
K9 and P9 pistols use 7 round (or larger) magazines.
MK9 and PM9 pistols use 6 round (or larger) magazines
http://www.kahr.com/Magazines/Magazines.asp
Regards,
Greg

[jmikesteen]

Thanks so very much for the reply sir, so most likely there is no difference in the A&G PM9/P9 that I got and the A&G MK9/K9? Oh, and by the way, I had to replace the follower in the Kahr mag with a Colt pocket nine follower.