Hey everyone. Just wanted to bring this to your attention. I got my brand new CW9 today, and ran about 300 flawless rounds through it, both JHP and FMJ. I was very pleased until I broke it down to clean it, and noticed that the leftmost edge of the barrel hood (looking at it from the chamber end) was either not properly machined, or has some sort of defect on it. The edge is jagged and sharp enough to cut myself on. I immediately inspected the breach face, where this portion makes contact, but did not notice any major damage. I am wondering, what should I do about it? Pictures below.





It may be hard to tell but I tried to show it.

Also, I noticed that the firing pin was not impacting the primer at the center, not even close. The impact is towards the top edge of the primer (when the round it in the chamber and locked forward). No failures so far, but wanted to know if this off-center strike is normal?