Magguts Available again for 9mm magazine

[Whiskeyhorse]

Interesting design. I saw a post about 5 years ago where the poster called it a flat spring. Not sure what kind of spring that is. Did some research and found nothing. I wonder if the fatigue rate is the same as the coil spring. When does Magguts recommend time to change out the magazine (round count), I also noticed on a video of the 365 15 round magazine, Magguts is just ONE piece not two different springs. They use the Flat spring only. Seems like this would be more attractive to owners of the Kahr's if it were one spring, instead of the weird two piece.

PS Just checked my magazines and it seems I do have one Magguts and working fine. I will check the 9mm later.

https://www.youtube.com/watch?v=7lsRfs9TWjA&t=12s

[gb6491]

Interesting design. I saw a post about 5 years ago where the poster called it a flat spring. Not sure what kind of spring that is. Did some research and found nothing. I wonder if the fatigue rate is the same as the coil spring. When does Magguts recommend time to change out the magazine (round count), I also noticed on a video of the 365 15 round magazine, Magguts is just ONE piece not two different springs. They use the Flat spring only. Seems like this would be more attractive to owners of the Kahr's if it were one spring, instead of the weird two piece.

PS Just checked my magazines and it seems I do have one Magguts and working fine. I will check the 9mm later.

https://www.youtube.com/watch?v=7lsRfs9TWjA&t=12s

I didn't like Magguts two spring design when they first came out, but they changed it by physically connecting the two springs. I'm good with that (even though I would prefer a one piece spring). https://www.kahrtalk.com/showthread.php?32971-Mag-Guts-for-9mm-is-here!&p=409918#post409918

The Magguts follower feeds very well; probably the best of any 9mm follower I've tried in a Kahr mag.

Regards,
Greg

[Whiskeyhorse]

Great picture you made of the spring fitting into the notch of the follower. Magguts should use your picture in their instructions.
I haven't looked at magguts for a few years. Did a quick look at their website and install instructions and could not tell what the guy was talking about with his video of fixing the notch to the follower. Too hard to see what he was doing. (a picture is worth a thousand words)